Using Porcelite with form2

Home Forums Porcelite Discussion Using Porcelite with form2

This topic contains 3 replies, has 3 voices, and was last updated by  biluagd 2 months, 1 week ago.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #761

    formwurx
    Participant

    Hi

    This resin is incredibly viscous – can I use it in a cleaned out formlabs resin cartridge, with grey setting, or do I need to pour manually and use it in open mode?

    thanks

     

    Jason

     

    #764

    handsaredigital
    Participant

    Place your empty grey cartridge in the form 2. Then manually fill up the resin tank for the form 2. The machine will recognize if there is two much resin. This will keep the wiper arm and heater on. The heater will reduce the viscosity of the resin.

    #772

    handsaredigital
    Participant

    I have been recently firing cups still attached to the supports. I print the cup upside down so the rim is connected to the supports. The base of the supports acts as a nice firing base for the cup. The cup is fired upside down.  The print fires much more even.

    #1155

    biluagd
    Participant

    Do you have success printing that way? Or open mode? Thanks

Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.

0 Items - $0.00